Roots BlowerIn the use of the process can not be separated from the maintenance, then the Roots blower should be how to carry out routine maintenance? On this issue Roots blower small make up to take you to understand.
使用罗茨鼓风机时，进口气体的温度不高于40摄氏度，轴承的工作温度不高于95摄氏度，燃油箱中的润滑油温度不超过65摄氏度 摄氏温度以确保在所施加的温度下不会发生任何事故。
When the fan is equipped with an outdoor unit, a rain shelter should be installed. It is not necessary to install the fan in a place where people make frequent payments to prevent injuries and burns. There should be enough space around the bottom of the root depending on the direction of the air intake and exhaust ports and the need for maintenance. Do not install the fan where flammable, explosive and corrosive gases are likely to occur to prevent fire and poisoning. When installing the fan unit, pay attention to whether the foundation is firm, whether it has a flat appearance and whether the foundation is above ground level.
The formation of a steady burn is excessive current. Check that the lubricant is not exhausted in all parts of the fan. If the fan is to be serviced regularly, it will be operated without oil, which will increase conflict, increase the motor load, and the current will be excessive. Check that the fan is blowing smoothly. If the wind is not flowing, the pressure will rise, the motor load will likewise increase, and then the current will be too high.
There are three ways to resolve a broken V-belt on a Roots blower: The fan needs to be removed and loaded after startup. Beware of a slipping V-belt, otherwise the temperature will rise rapidly and the V-belt rubber will break. It is the pulley of the motor and the fan, which must be parallel. Also, the diameter of the pulley determines the life of the V-belt. Try to make the diameter larger when machining.
The causes of high Roots blower temperature are to eliminate the problem in time: too much oil in the fuel tank, too thick, too dirty; the filter or muffler is clogged; the pressure is higher than the specified value; the impeller is excessively worn and has a large clearance; poor ventilation, high room temperature, high inlet temperature; the working speed is too low, the belt slips.
The quality of the fan itself, with poor clearance fit in many parts, creates a clash of classifications, which then partially breaks down, increasing the load on the motor, which leads to stabilization of the fuse.